|
Wind controls (for a fountain) Are your fountains too high in the wind? then you need wind controls
|
| Wind controls are very useful They help to "bend the
rules of physics" where fountain height / pool ratio is concerned.
The digital anemometer includes 6ft of cable, (Extendable to 500ft.) It mounts on either a 1” conduit or as this picture shows on a batten in free air. Relay outputs (via the A2 controller) are 2 Amp for switching small pumps or contactors. How it works (single stage) It is very simple in operation, at a pre determined speed (user selectable) a set of contacts will operate, this can be used to stop the pump How it works (duel stage) If there is either a variable speed pump or diverter valve fitted the first stage can operate this, the second stage will stop the pump running. Both parameters for when to operate are user selectable. The anemometer should be mounted in the vicinity of the fountain so that it gets the same wind conditions. As wind speed reduces so the contacts return to normal, so the fountain can continue to run as it was.
|
|
||||
 Here is a complete set of wind controls Downloadable PDF cut sheet |
|||||
