water switch

A water switch is a "switch" that can make a water stream stop and start at your control.

The water stream depends on the nozzle that is fitted to the "output port" Almost any nozzle can be fitted but the best is a komet nozzle

During operation water is pumped in via the input port, and exits via the output port, however, by electrically switching from the output port to the exhaust port The visible output port is no longer emitting water (from a viewing point, the water has stopped) this can be done as often as required. With several water switches in a row you can then make the water switches switch in sequence giving the appearance the water is chasing along a set line. (Assuming they are in a line)

The following should also be noted:

	A Water switch is a switch, it only switches form the main port to exhaust port (and slightly in-between if required)
	It is not a laminar jet
	The water stream can not be internally illuminated, but it can be externally illuminated
	The water switch does not come with the following, Pump, output outlet nozzle or 24 v dc power supply, controls, since this depends on your installation
	The water switch weighs approximately 5.3 Kilos
	It is approximately 33cm tall and 21 cm wide
	The silver vertical pipe is a breather pipe, and must be above the water surface